Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Izaki, Kenji; Noda, Kimio; ; Kashimuta, Yoshio*
JNC TN8410 2001-005, 30 Pages, 2001/01
JNC-TN8410-2001-005.pdf:0.62MB
Stack monitoring is the most important work in radiation control works. Exhaust monitors used for stack monitoring have the background (which is the counts by natural radio-nuclides) on normal condition, and the values of the background vary with the facilities. Therefore, if the value of background is high, it is difficult to estimate rapidly the radioactive concentration in the exhaust. In order to estimate rapidly the radioactive concentration in exhaust, we analyzed the behavior of natural radioactivity in the facilities and examine the technique fo reducing the value of the background. As a result of the examination, we found that it is possible to estimate rapidly if we change over the monitoring point to immediately after the HEPA filters on the exhaust duct. In this reports, the analyzed results of behavior of natural radio-nuclides in the facilities and the technique for reducing the values of the background are described. To reduce the value of the background has a major effect on not only rapidly estimating the radioactive density in the exhaust but also finding the unusual things on stack monitoring.
Endo, Hideo; Seki, Masayuki; ; *; *
JNC TN8410 2000-007, 89 Pages, 2000/03
JNC-TN8410-2000-007.pdf:6.28MB
(1)Outline of examination. Various test specimens were made to evaluate and confirm the weld strength properties of the oxide dispersion strengthened (ODS) cladding tube material (martensitic and ferritic steel), which had been manufactured in JFY 1997. The examination consisted of tensile tests (RT,650
C, 700C, 800C), internal pressure creep tests, internal pressure burst tests, and a rapid heating burst tests. (2)Examination results. The results of the tensile tests are as follows: (ferritic and martensitic) (a)All test specimens from RT to 700C failed in the tube. The weld zones had not failed. (b)The test specimens at 800C failed in the weld zones. There was little elongation. (ferritic) (a)The weld zone had fine grain structure and carbide precipitates. (martensitic) (a)Carbide had precipitated in the weld zone. From these results, the strength of weld zone decreased extremely at temperatures exceeding the endurance limit (700C) All of the internal pressure burst test specimens and the rapid heating burst test specimens failed in the tube and not the weld zone. (3)The quality assurance method of the test specimens. The weld reliability of the test specimens were confirmed by the process control of the welding conditions, by using control test specimens, and ultrasonic testing. Confirmation of the process control of the welding conditions; current wave, the voltage waveform, the accelerogram, and the displacement ripple in the welding process was recorded to assure an abnormal value had not occurred. (Process control of welding condition) The results the current waveform, voltage waveform, accelerogram, and the displacement waveform were excellent. (test specimens) The weld joint was excellent based on metallography examination. (Ultrasonic testing) The length of the weld joint was measured and found to be adequate. The reliability the weld joint can be assured by using the above-mentioned method.
*; *;
Radioisotopes, 30(9), p.475 - 479, 1981/00
no abstracts in English
